[ 81 ]
Mobile Internet Services (WAP)
12
and other information, contact your network operator or service
provider.
• The following options depend on the selected data bearer:
WHEN GSM DATA IS THE SELECTED DATA BEARER:
• Dial-up number - Key in the phone number and press OK.
• IP address - Key in the address, press for a period, and press OK.
You obtain the IP address from your network operator or service
provider.
• Authentication type - Select Secure or Normal.
• Data call type - Select Analogue or ISDN.
• Data call speed - Select the speed you want to use, or select
Automatic. Automatic is available only if the current selected data
call type is Analogue. The actual data call speed depends on the
service provider.
• Login type - Select Manual or Automatic. If you select Automatic, the
login type uses the user name and password keyed in the following
settings. If you select Manual, the login information is required when
establishing a connection.
• User name - Key in the user name and press OK.
• Password - Key in the password and press OK.
WHEN GPRS IS THE SELECTED DATA BEARER:
• GPRS connection - Select Always online or When needed. If you select
Always online, the GPRS connection is automatically established
when you switch on the phone. The indicator is shown on the
display in standby mode. The GPRS connection is not closed when you
end a WAP connection. If you select When needed, the GPRS
connection is established when you connect to a WAP service and
closed when you end the WAP connection.
• GPRS access point - Key in the access point name and press OK. An
access point name is needed to establish a connection to a GPRS
To Next Page
Loading...
