Nokia 6680 - Writing Text; Traditional Text Input

Messaging
46
Copyright © 2005 Nokia. All rights reserved.
delivery report of a multimedia message that has been
sent to an e-mail address might not be possible.
Tip! When you have opened any of the default
folders, you can switch between the folders by
pressing or .
To enter and send service requests (also known as USSD
commands), such as activation commands for network
services, to your service provider, select Options > Service
command in the main view of Messaging.
Cell broadcast is a network service that allows you to
receive messages on various topics, such as weather or
traffic conditions from your service provider. For available
topics and relevant topic numbers, contact your service
provider. In the main view of Messaging, select Options
> Cell broadcast. In the main view you can see the status
of a topic, a topic number, name, and whether it has been
flagged ( ) for follow-up.
Options in Cell broadcast are Open, Subscribe/
Unsubscribe, Hotmark/Remove hotmark, Topic,
Settings, Help, and Exit.
Cell broadcast messages cannot be received in UMTS
networks. A packet data connection may prevent cell
broadcast reception.
Writing text
Traditional text input
and indicate the selected case. means
that the first letter of the word is written in upper case,
and all other letters are automatically written in lower
case. indicates number mode.
The indicator is shown on the top right of the
display when you are writing text using traditional text
input.
• Press a number key ( — ) repeatedly
until the desired character appears. There are more
characters available for a number key than are printed
on the key.
• To insert a number, press and hold the number key.
• To switch between letter and number mode, press and
hold .
• If the next letter is located on the same key as the
present one, wait until the cursor appears (or press
to end the time-out period), and enter the letter.
• To erase a character, press . Press and hold to
clear more than one character.
• The most common punctuation marks are available
under . Press repeatedly to reach the
desired punctuation mark.