[ 47 ]
Basic operations
Connect the headset
1 Plug the headset jack into the Pop-Port
TM
connector at the bottom end of your phone.
2 Position the headset on your ear as it
appears in the illustration to the right.
With the headset connected, you can
make, answer, and end calls as usual.
• Use the keypad to enter numbers
• Press the Talk key to place a call
• Press the End key to end a call
Adjust display brightness
1 Press Menu 4-4-5 (Settings - Display settings - Display brightness).
After a brief pause, a bar chart appears in the display indicating the
current brightness level.
2 Press the Left selection key or the Right selection key to adjust the
brightness to your preference.
Change the Xpress-on
TM
covers
Important: Before changing covers, ensure the phone is powered
off and disconnected from the charger or any other device. Always
store and use the phone with the covers attached.
REMOVE THE BACK COVER AND THE BATTERY
This procedure is illustrated in the section “Use the battery” on page 20.
1 Push the back cover release toward the top of the phone.
2 Lift the back cover away from the phone to remove.
To Next Page
Loading...
