Getting started
3
English
• Constant blue light indicates that
the inserted spare battery is not
fully charged. If the phone is
inserted, the spare battery is only
being charged when the phone
battery is fully charged.
• The light indicator can be turned
off by pressing the switch on the
back of the desk stand. To turn
the light indicator on again, press
the switch.
• If the light indication is off
without pressing the switch, the
reason might be one of the
following: a non-compatible
charger is used or the spare
battery temperature is too high.
Check the compatibility of the
charger and use only compatible
Nokia chargers. If the spare
battery temperature is too high,
it is not being charged. When the
temperature of the spare battery
is back to normal, charging starts
and the light indication turns on
again.
■ Switch the phone on
and off
Warning: Do not switch the
phone on when wireless
phone use is prohibited or
when it may cause
interference or danger.
Press and hold the
power key as shown.
If the phone asks for
a PIN or a UPIN code,
enter the code (for
example, displayed as
****), and select OK.
When you switch on your phone for
the first time, and the phone is in
standby mode, page 6, you will be
asked to get the configuration
settings from your service provider
(network service). Confirm or decline
the query. See Connect to service
provider support, page 44, and
"Configuration settings service",
page xi.
■ Open the keypad
To open the keypad,
slide the phone as
shown.
9237415_8800_2_en_zh.fm Page 3 Tuesday, April 19, 2005 10:26 AM
To Next Page
Loading...
