Nokia A032 Getting Started Guide

Installing the Nokia A032
15
Connecting to an existing 10baseT LAN
If you have an existing 10baseT wired Ethernet
LAN, you can connect the Nokia A032 to it
now:
1 Connect a twisted pair 10baseT cable to the
RJ45 connector in the rear of the unit.
2 Connect the other end of the cable to a local
hub or a wall jack.
In the next chapter, you’ll test the Nokia A032
by using a wireless station to communicate with
a station on the wired LAN.
Powering up the Nokia A032
1 Insert the power unit’s plug into the power
connector on the rear panel of the Nokia
A032.
2 Connect the power unit to an AC wall
outlet.
The unit will start up, and some of the LEDs
will flash (see page 29). When the unit is
initialized and functioning correctly, the
alert LED will go out.
3 If the
alert LED still does not go out, an
error code may be displayed on the
info
LEDs. Please see Initialization error codes
on page 34.
The lan link LED
indicates a good
10base-T connection.

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English