30
Nokia A032 Getting Started
Displaying the number of users
While in Normal mode, press and hold in the
mode button. The info LEDs now display the
number of wireless
users – the lower row of
symbols applies.
For example, if the
1+, 2+ and 4+ LEDs are lit,
there are between 4 and 7 stations associated
with the Access Point.
Special modes
Use the mode button to start in special modes:
• Learn mode – Use this to perform initial
configuration on your Access Point, as
described in Setting up and testing on
page 17.
• BIOS mode – Use this to load new
firmware. See the Upgrading in the
Advanced User Guide for more details.
Starting in Learn mode
To start in Learn mode:
1 Switch off the unit.
2 Press and hold the
mode button while
switching on again.
3 Release the
mode button one second after all
the
info LEDs go off.
The unit should then follow what appears to be
a normal initialization sequence. However, at
the end of the sequence the
info LEDs will
display a ‘chasing’ pattern in which one LED
rapidly circulates around the panel.
Note: The Nokia A032
has no integral power
switch – switch on
and off at the wall
outlet or by removing
the power connector
from the rear of the
unit.
To Next Page
Loading...
