Supplementary information
31
Starting in BIOS mode
1 Switch off the unit.
2 Press and hold the
mode button while
switching on again.
3 Keep holding the
mode button.
After one second, all the
info LEDs will go
off. After a further five seconds, all the
info
LEDs will come on again.
4 Release the
mode button.
Using Learn mode over a wired LAN
Once the Access Point has an IP address you
can configure in Normal mode using a web
browser from either the wired or wireless LAN.
Learn mode is especially useful before the IP
address is defined.
Normally in learn mode, the LAN is
disconnected and configuration occurs only via
a wireless station. In some circumstances you
might need to assign an IP address over the
wired LAN. In this case follow the procedure
described in this section. Note that when in
normal mode (not Learn mode) configuration
can be performed either by wireless or LAN
connection at any time.
1 Remove the wireless LAN card from the
Access Point.
2 Switch off the Access Point.
3 Start the Access Point in Learn mode.
Follow the instructions on page 19 if you’re
unsure. In this instance, while in Learn
mode the
air tx and air rx LEDs will slowly
alternate to indicate that the radio is not
present.
To Next Page
Loading...
Need help?
General
