48
Camera
active toolbar settings return to the default settings after you close the camera,
but the main settings remain the same until you change them again.
Still image camera settings
To change the main settings, select Options > Settings.
To set the image resolution (only available in the main camera), select Image
quality. The better the image quality, the more memory the image consumes. To
print the image, select Print 5M - Large, Print 3M - Large, or Print 2M - Medium. To
send it through e-mail, select E-mail 0.8M - Med.. To send the image through
multimedia messaging (MMS), select MMS 0.3M - Small.
To select whether to see the captured image after it is captured or to continue
capturing images immediately, select Show captured image.
To add GPS location coordinates to each image file, select Record location > On.
Receiving a GPS signal may take time or the signal may not be available.
To allow the zoom increments to be smooth and continuous between digital and
extended digital zoom, select Extended digital zoom > On (continuous) (main
camera only). To allow the zoom increments to pause at the digital and extended
digital step point, select On (paused). To limit the zoom to where the selected
image quality is maintained, select Off.
To return the default values to the camera settings, select Restore camera
settings.
Video settings
To change the main setting in video mode, select Options > Settings.
To set the quality of the video clip, select Video quality. Select Sharing if you want
to send the video clip using a multimedia message.
To add GPS location coordinates to the video clip, select Record location > On.
Receiving a GPS signal may take time or the signal may not be available.
To reduce the effect of the camera shaking when recording a video, select Video
stabilisation > On.
To mute sound recording, select Audio recording > Mute.
To view the first frame of the recorded video clip after the recording stops, select
Show captured video. To view the video clip from the active toolbar, select Play
(main camera) or Options > Play (secondary camera).
To apply the default values to the camera settings, select Restore camera settings.
To Next Page
Loading...
