Automatic redial — Set your device to
make a maximum of 10 attempts to
connect the call after an unsuccessful
call attempt. To stop automatic
redialing, press the end key.
Show call duration — Display the
length of a call during the call.
Summary after call — Display the
length of a call after the call.
1-touch dialing — Activate 1-touch
dialing.
Anykey answer — Activate anykey
answer.
Noise cancellation — Activate
earpiece active noise cancellation.
Contact search — Activate contact
search in the home screen.
Network settings
Select Menu > Ctrl. panel > Settings
and Phone > Network.
To select the network mode, select
Network mode and Dual mode,
UMTS, or GSM. In dual mode, the device
switches automatically between
networks.
Tip: Selecting UMTS enables faster data
transfer, but may increase the demand
on battery power and reduce the
battery life. In regions close to both GSM
and UMTS networks, selecting Dual
mode may cause constant jumping
between the two networks, which also
increases the demand on battery
power.
To select the operator, select Operator
selection and Manual to select from
available networks, or Automatic to set
the device to select the network
automatically.
To set the device to indicate when it is
used in a microcellular network (MCN),
select Cell info display > On.
Connection settings
Select Menu > Ctrl. panel > Settings
and Connection.
Select from the following:
Bluetooth — Edit the Bluetooth
settings.
USB — Edit the data cable settings.
Destinations — Set up new or edit
existing access points. Some or all
58 Settings
www.nokia.com/support
Cyan
To Next Page
Loading...
