NSI CPE safety guidelines Nokia WiFi Beacon 6 Product Guide
6 3FE-47429-AAAA-TCZZA Issue: 01
2 ANSI BEACON 6 safety
guidelines
This chapter provides information about the mandatory regulations that govern the
installation and operation of devices in the North American or ANSI market.
2.1 Safety instructions
This section describes the safety instructions that are provided in the BEACON 6
customer documentation and on the equipment.
2.1.1 Safety instruction boxes in customer
documentation
The safety instruction boxes are provided in the BEACON 6 customer
documentation. Observe the instructions to meet safety requirements.
The following is an example of the Danger box.
Danger — Possibility of personal injury.
The Danger box indicates that the described activity or situation may pose a threat
to personal safety. It calls attention to a situation or procedure which, if not
correctly performed or adhered to, may result in death or serious physical harm.
Do not proceed beyond a Danger box until the indicated conditions are fully
understood and met.
The following is an example of the Warning box.
Warning 1 — Possibility of equipment damage.
Warning 2 — Possibility of data loss.
The Warning box indicates that the described activity or situation may, or will,
cause equipment damage, loss of data, or serious performance problems. It
identifies a possible equipment-damaging situation or provides essential
information to avoid the degradation of system operations or data.
To Next Page
Loading...
