Nokia HA-0336G-A - Page 72

Configure a Beacon 6 (HA-0336W-B) Nokia WiFi Beacon 6 Product Guide
72 3FE-47429-AAAA-TCZZA Issue: 01

Connection Type Select a connection type: IPoE or PPPoE
Connection Mode Choose the connection mode from the drop-down menu; either Route mode or
Bridge mode

IP Mode Choose an IP mode from the drop-down menu: IPv4 or IPv6
Enable/Disable Select this checkbox to enable the WAN connection
NAT Select this checkbox to enable NAT
Service Select the checkboxes to enable service types for this connection
Enable VLAN Select this checkbox to enable VLAN
VLAN ID Enter the VLAN ID
VLAN PRI Enter the VLAN PRI
WAN IP Mode Choose an IP mode from the drop-down menu
Address Method Choose the address method from the drop-down menu
Enable Prefix Delegation Select the checkbox to enable prefix delegation
Prefix Type Choose the prefix type from drop-down menu
 Table 21 WAN parameters - Bridge Mode
Field Description
WAN Connection List Choose a WAN connection from the drop-down menu to set the connection
parameters

Connection Mode
(1)
 Choose the connection mode from the drop-down menu; either Route mode or
Bridge mode

Enable/Disable Select this checkbox to enable the WAN connection
Service Select the checkboxes to enable service types for this connection
Enable VLAN Select this checkbox to enable VLAN
VLAN Mode Choose a VLAN mode from the drop-down menu
LAN port binding Select the checkbox(es) to bind selected LAN ports to the WAN connection
SSID port binding Select the checkbox(es) to bind selected SSID ports to the WAN connection.
The options are SSID ports 2, 3, 4, and 6-8; SSID ports 1 and 5 cannot be
selected and are therefore grayed out.

Notes
(1)
A warning pop-up message is displayed when Bridge mode is selected: “Please remove and re-insert the cables connected to the LAN ports.
Reconnect to the SSIDs associated to the bridge WAN. Make sure that the extension beacons are not connected to the LAN ports
associated to the bridge WAN.” You can then accept or cancel the operation.


2 Configure a specific WAN connection.
