Make calls
26
Settings
Person-to-person connection settings
A person-to-person connection is also known as a Session
Initiation Protocol (SIP) connection. The SIP profile
settings must be configured in your device before you can
use Video sharing. Setting up a SIP profile allows you to
establish a live person-to-person connection to another
compatible device. The SIP profile must also be
established to receive a sharing session.
Ask your network operator or service provider for the SIP
profile settings, and save them in your device. Your
network operator or service provider may send you the
settings over the air or give you a list of the needed
parameters.
If you know a recipient’s SIP address, you can enter it on
your contact card for that person. Open Contacts from
your device main menu, and open the contact card (or
start a new card for that person). Select Options > Add
detail > Web address. Enter the SIP address in the format
sip:username@domainname (you can use an IP address
instead of a domain name).
Share live video and video clips
To receive a sharing session, the recipient must install
Video sharing and configure the required settings on
their mobile device. You and the recipient must both be
registered to the service before you can start sharing.
1 Select Options > Share video > Live or Clip.
If you selected Clip, a list of video clips opens. Select a
video clip you want to share and Options > Send
invitation.
2 Select the SIP address of the recipient to which you
want to send the invitation from the contacts list.
If the SIP address of the recipient is not available, enter
a SIP address.
3 Sharing begins automatically when the recipient
accepts the invitation.
4 Select Pause to pause the sharing session. Select
Continue to resume sharing. If sharing a video clip, you
can rewind and fast forward the clip.
5 To end video sharing, select Stop or close the camera
slider. Video sharing also ends if the active voice call
ends.
Accept an invitation
When someone sends you a share invitation, an invitation
message is displayed showing the sender’s name or SIP
address. If your device is not set to Silent, it rings when
you receive an invitation.
If someone sends you a share invitation and your device is
turned off or you are not within UMTS network coverage,
you will not know that you received an invitation.
To Next Page
Loading...
Need help?
General
