Tools
99
To create a new access point, press , and select Tools >
Settings > Connection > Access points.
An access point may be protected ( ) by your network
operator or service provider. Protected access points
cannot be edited or deleted.
Access points
Tip! See also ‘Receive MMS and e-mail settings’, p. 56,
‘E-mail’, p. 63, and ‘Access the Web’, p. 72.
Follow the instructions given to you by your service
provider.
Connection name—Give a descriptive name for the
connection.
Data bearer—Depending on the data connection you
select, only certain setting fields are available. Fill in all
fields marked with Must be defined or with a red asterisk.
Other fields can be left empty, unless you have been
instructed otherwise by your service provider.
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
Access point name (for packet data only)—The access
point name is needed to establish a connection to the
packet data and UMTS networks. You obtain the access
point name from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service
provider. The user name is often case-sensitive.
Prompt password—If you must enter a new password
every time you log in to a server, or if you do not want to
save your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service
provider. The password is often case-sensitive.
Authentication—Select Normal or Secure.
Homepage—Depending on what you are setting up, write
the Web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type—Select the Internet protocol type to use:
IPv4 settings or IPv6 settings. The other settings depend
on the selected network type.
Phone IP address (for IPv4)—Enter the IP address of your
device.
Name servers—In Primary name server:, enter the IP
address of the primary DNS server. In Second. name
server:, enter the IP address of the secondary DNS server.
Contact your Internet service provider to obtain these
addresses.
To Next Page
Loading...
Need help?
General
