Nokia NHM-1 Series - Phoenix Service SW Installation Guide; Phoenix Software Overview; Supported Operating Systems; Phoenix Hardware Requirements

8 pages

To Next Page

To Previous Page

CCS Technical Documentation Disassembly and Reassembly Instructions

Company confidential NHM-1

Open the connector carefully by using the SRT-6. The Display is attached with four snaps to the Engine

Shield. Release the snaps by using the SRT-6 tool.

Repeat the same procedure on the other side of Dis-

play.

Now, the Display can be removed.

Push down the Earpiece from its guidance carefully. A

screwdriver can be used for this. Do not damage the

spring contacts of the Earpiece. Note the right position

of the guiding pin from the Earpiece when assembling.

Unscrew the two TORX PLUS® size 6 screws, using the

order shown. For assembly, the reverse order and a

torque of 24Ncm have to be used.

There are two snaps, which lock the engine assembly.

Use the Opening Tool to release the snaps.

Now the engine assembly can be taken away.

Other manuals for Nokia NHM-1 Series