NHM-1 Company confidential
Disassembly and Reassembly Instructions CCS Technical Documentation
Page 6 Copyright Nokia. All rights reserved Issue 1 11/03
To separate the UI-PWB from Engine Shield use SRT-6
only. Place it between UI-PWB and Engine Shield and
slide along the edge carefully as shown in the picture.
Then use the opening tool as a lever.
Now, the UI-PWB, Engine PWB and Engine Shield can
be separated from each other.
Remove the Light Guide by opening the snaps. To remove the DC Jack, place tweezers between the
spring contacts and under the Jack. You’ll need to use
additional force to pull the Jack upwards.
Remove the Microphone from its guidance carefully.
Do not damage the spring contacts.
Remove the Vibra Motor from its guidance
Camera Module drops out when turning B-Cover. Remove the IR Window as shown in the picture.
To Next Page
Loading...
