Need help?Do you have a question about the Nokia NHM-1 Series and is the answer not in the manual?
General| Brand | Nokia |
|---|---|
| Model | NHM-1 Series |
| Category | Transceiver |
| Language | English |
Introduction to Phoenix Service Software, designed for modern cellular phone technology.
Lists operating systems compatible with Phoenix Service Software.
Specifies minimum and recommended hardware for Phoenix installation and use.
Briefly describes Phoenix software installation and usage, referring to help files.
Pre-installation checks and requirements for Phoenix Service SW, including dongle and software package.
Instructions to start the Phoenix installation process.
Install phone-specific data packages for Phoenix Service Software.
Configure network connections for Phoenix Service Software.
Update flash support files for FPS-8 and FLS-4S tools.
Details on Product Data Package for Phoenix, including its purpose and prerequisites.
Connection settings for FLS-4S POS Flash Device, specifying Media and COM Port.
Connection settings for FPS-8 Flash Prommer, specifying Media, Port Num, and COMBOX.
Prerequisites for updating flash support files, including Phoenix SW and data packages.
Procedure for installing flash support files, including running the setup executable.
Steps to activate FPS-8 for phone programming, involving an activation request file.
Procedure to deactivate FPS-8, typically for repair or sending the box elsewhere.
Prerequisites for installing JBV-1 SW update, including hardware and software.
Procedure for updating phone software using FPS-8 or FLS-4, including connection setup.
Steps to prepare for Energy Management Calibration, including connections and power supply.
Table detailing parameter limits for Energy Management Calibration.
General guidelines and order for performing GSM RF tuning operations.
Overview of tools used for RF tunings, including MJS-43 Module Jig and JBV-1.
Procedure to calibrate RX channel select filter in GSM phones.
Procedure for RX calibration, covering EGSM and GSM1800 bands, including AFC tuning.
Procedure for TX I/Q tuning, adjusting DC offsets, amplitude, and phase differences.
Lists the order for WCDMA RF tuning operations.
Procedure for WCDMA RF channel filter tuning, no external instruments needed.
Details on WCDMA TX control modes: Manual and Algorithm, for AGC, PA Bias, and DC/DC converters.
To Next Page
