CCS Technical Documentation
NHM-1
Issue 1 11/03 Copyright Nokia. All rights reserved.. Page 81
WCDMA TX Power Detector Tuning
This alignment requires use of a power meter (“thermal” sensor) or vector signal analyser.
The wideband mean power should be measured in a 5MHz BW.
• Calibration is started from the Phoenix menu:
Tunings/WCDMA/Power detector calibration
• Press “Start” .
• Tune the output power with the slider to +21 dBm. The power can be set with
either the slider or the arrow keys on the keyboard. Press “Accept”
To Next Page
Loading...
