Nokia NHM-1 Series - Receiver Tuning Operations; RX Channel Select Filter Calibration

To Next Page

To Previous Page

NHM-1

CCS Technical Documentation

Receiver tuning operations

RX Channel Select Filter Calibration

• Extra equipment / external RF signal not needed

• Must be done before other RX calibrations

• This function is used to calibrate RX channel select filter in GSM

Phones.

• Rx Channel select filter is tuned only in one band = Single calibration for

both bands

Select Tuning => GSM => Rx Channel select filter calibration

Press “Tune" to start the tuning.

Values will be saved to phone when “Save to Phone” tick box is checked.

If “Save to Phone” tick box is not checked, the values are not saved to the phone when

you stop the tuning or exit the dialog.

Tuning values must be in the range 0…31.

Select “Stop”.

Close the “RX Channel Select Filter Calibration “– dialog to end tuning.

Other manuals for Nokia NHM-1 Series