Nokia NHM-1 Series - WCDMA RX Band Response Tuning

To Next Page

To Previous Page

NHM-1

CCS Technical Documentation

WCDMA RX Band Response Tuning

A signal generator is needed and test signal applied into NHM-1’s connector.

• Calibration is started from the Phoenix menu:

Tunings/WCDMA/RX band response calibration

• Press “Start” then “Tune”.

• The calibration routine will define the signal generator settings for you.

• Set frequency and settings to defined values and allow the tuning to continue by

pressing “OK”.

• After this low and high frequency compensation values for RX band response will

be sored into PM when you press “Yes” to save changes.

Note: With the “Read” - button you can check the values stored in PM.

Other manuals for Nokia NHM-1 Series