P.A.M.S.
Technical Documentation
NME–2A
Installation Instructions
Page 13
Original 08/97
87
Bosch P/N 0–332–204–150 12
V, 30 A. SPDT
12 V d.c.
Fuse 200 mA
(not supplied)
85
87A
30
86
GND
CONTROLLED
DEVICE, e.g.
MOTOR AN-
TENNA
GND
Supply for de-
vice
From ANTC line
(orange wire)
Figure 4. Connection – Power Antenna Control
Testing
Once installed, the equipment should be tested to ensure that it is
operating satisfactorily and that the position of the units does not impair on
the driver’s ability to control and operate the vehicle in any way.
Use the phone to make a call when the vehicle is parked with the engine
running. During the call, switch off the engine. Ensure that the phone is
operational with the engine running and with the engine switched off. For
operating information refer to the ’User Guide’ supplied with the phone.
To Next Page
Loading...
