Nokia OZO - Basic Operation

Basic Operation
Power ON-OFF
To power on the device slide the
power button (A) to the outmost right
position and release. The button will
stay in an intermediate position and
theindicator(LED)inthecenterofthe
button indicates booting (by blinking
slowly).
Oncethebootinghasnishedthe
indicator discontinues blinking and
remains lit. The device always boots
into “Broadcasting” mode to allow
immediate preview over SDI.
For complete shutdown slide the
power button to the outmost left
position.
WiFi
By default the device is enabling WiFi
immediately after booting is complete.
The WiFi-LED (B) is blinking slowly to
indicate readiness to connect.
The OZO Remote host computer
must have WiFi enabled to connect
to the OZO Camera. The WiFi-button
indicator discontinues blinking and
remains lit to indicate a successful
connection to the OZO Remote
Application.
To boot the device without WiFi
(airplanemode)pressandholdthe
WiFi button during startup until
bootinghasnished.
A B
25