CC Technical Documentation Disassembly
RM-11
Issue 2 09/2005 ©2005 Nokia Corporation Confidential Page 3
5. Remove the six screws that hold the C-Cover in
place (torque 21Ncm and speed 480rpm).
6. Remove the PWB/UI module from the C-Cover.
7. Remove the UI module from the engine module.
Note: The UI module and the engine board are linked
together by two board-to-board connectors. Be careful
not to touch them.
UI module and engine module after separation.
8. Remove the microphone by gently pressing on its
edge or by placing tweezers between the frame and
the microphone and lifting it out of the frame.
9. Remove the speaker by lifting it from the guiding
pin.
Note: The speaker is attached into the frame with adhe-
sive tape. Therefore, it may not loosen easily.
Step-by-Step Disassembly Instructions (Model 3205)
To Next Page
Loading...
