Edit a GPRS access point
Select an access point group and access point marked with
. Follow the instructions
from your service provider.
Select from the following:
Access point name — The access point name is provided by your service provider.
User name — The user name may be needed to make a data connection, and is usually
provided by your service provider.
Prompt password — If you must enter the password every time you log in to a server,
or if you do not want to save your password in the device, select Yes.
Password — A password may be needed to make a data connection and is usually
provided by your service provider.
Authentication — To always send your password encrypted, select Secure. To send
your password encrypted when possible, select Normal.
Homepage — Depending on the access point you are setting up, enter the web address
or the address of the multimedia message center.
Use access point — Set the device to connect to the destination using this access point
after confirmation or automatically.
Modify advanced GPRS access point settings
Select Options > Advanced settings.
Select from the following:
Network type — Select the internet protocol type to transfer data to and from your
device. The other settings depend on the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of your device.
DNS addresses — Enter the IP addresses of the primary and secondary DNS servers, if
required by your service provider. To obtain these addresses, contact your internet
service provider.
Proxy server address — Enter the address of the proxy server.
Proxy port number — Enter the port number of the proxy server.
Wi-Fi access point settings
Select Menu > Settings and Connectivity > Destinations > Access point, and follow
the instructions.
Edit a wireless LAN (Wi-Fi) access point
Select an access point group and access point marked with
. Follow the instructions
from your WLAN service provider.
96 Connectivity
© 2009 Nokia. All rights reserved.96
To Next Page
Loading...
