12
Fig. 27
ONLY FOR JET HELMETS OR FLIP-UP HELMETS
Secure the battery-holder support to the
right side of the helmet, lining up the holes
with the pins on the shell (Fig. 27)
Fig. 28
ONLY FOR FULL FACE HELMETS
Position the battery in the right polystyrene
cheek pad housing (Fig. 28).
Before you place the speaker in its housing, apply the Velcro pad to the polystyrene cheek pad
(right side).
Position the loudspeaker in its housing obtained in the polystyrene cheek pad (right side).
Replace the polystyrene cheek pad (right side), positioning the cable in the groove you see in the
cheek pad.
Fig. 29
ONLY FOR FULL-FACE HELMETS
Insert the chin guard (microphone side),
gently placing the microphone in its housing.
Then press down on the red tab until the chin
guard is locked in place on the helmet. (Fig.
29)
To Next Page
Loading...
