Customer Confidence 10
Figure 11: License key retrieval.
NOTE: The date and time the gateway receives a valid license from our server for the first time is considered the
Software License Subscription start date.
Step 4: Configuring the System
Log in to the Edge Gateway and use the graphical Web Management Interface (WMI) to configure the product’s
features. You have now established a basic configuration for the EG that enables internet connectivity.
For additional information about the available EG features, refer to Chapter 2 of the User Guide specific to your
EG. For example:
• To establish various billing and authentication methods, see Defining the AAA Services.
• To establish hotel billing, see Assigning a PMS Service.
Step 5: Configuring EG DHCP Server Settings
DHCP Server is enabled by default. To configure the DHCP Server, go to DHCP under the Configuration menu. You
can either modify the default DHCP pool, add additional pools or delete the default DHCP pool and create a new
pool. The total lease pool size recommendation is 75% more than the number of licensed subscribers. Table 3
shows the factory default DHCP server settings.
DHCP Relay (Yes / No)
If No, skip to DHCP Server
DHCP Relay Server IP Address
DHCP Relay Agent IP Address
DHCP Server (Yes / No)
Only if the DHCP Relay is disabled
To Next Page
