Norac UC5 - Automatic System Setup


14

3.7. AutomaticSystemSetup
 Allboomsectionswillmoveduringtheautomaticsetup.
 Peopleandequipmentmustbeclearofsprayerboom.
 Ensuretheboomshavesufficientrangetoliftfullyandareclearofanypowerlines.
Unfoldthesprayerinalocationthatisrelatively
levelandwherethesensorsareoverbaresoilorgravel.
Donotconducttheretuneoverstandingcrop,weedsorgrass.Also,avoidconcreteorasphaltsurfaces.
Ensuretheboomrollsuspensionsystemisfunctioningproperlyandsmoothly.Frictiononwearsurfaces
can be relieved using lubricants (grease, etc.) or
 adjustment.Properly tuned suspension systems will
optimizeUC5™performance.
For best results, the hydraulic system should be under a normal load and at a normal working
temperature.
 Start the solution pump and run the sprayer’s engine at a normal working RPM for the entire
setup.
 Cycleallboom
sectionsupanddownmanuallyforfiveminutestowarmtheoil.
 Fortrailedsprayers,ensureanyhydraulicflowcontrolsareadjustedfornormalfieldoperation.
 Changing the hydraulic flow controls after or during the system setup will affect the UC5
performance.