1
PN 2006019–ENG Rev. I
Norac UC5
Norac Unlock
The Features Tab is where you can enter unlock
codes. Unlock codes are unique to the serial
number of each display and the feature
registration number. You must supply these
numbers to your dealer when purchasing any
unlock codes. Press to enter the unlock
code and press to enable the feature.
Norac UC5 can be used with or without an unlock but how you setup and run the system differs depending on whether
the system is locked or unlocked and using CAN A or CAN B.
Create Configuration
To create a configuration, make the following button presses to start the Configuration Wizard and then follow the
instructions given on the display. The configuration can be started in two places:
OR
OR
The wizard will guide you through the process of selecting or creating a vehicle, implement and controllers.
Your Operating Configuration will then be viewable when you start a new Field Operation with the Field Operation Wizard.
Setup Configuration
Locked UnLocked
CAN A No Functionality
Setup using Ag Leader Screens
Operate using Ag Leader Screens
CAN B
Setup using Universal Terminal Screens
Operate using Universal Terminal Screens
Setup using Universal Terminal Screens
Operate using Ag Leader Screens
Consule Setup
General
Display
Features
AgFiniti
Advanced
Hardi Sprayer
ISOBUS
Norac UC Interface
Feature
Automatic Swath
Multiple Product
Feature Description:
Unlock
Enabled
Enabled
Enabled
Enabled
Enabled
Status
Select Your Specific
Configuration
To Next Page
Need help?
General
