Need help?Do you have a question about the Norac UC5 and is the answer not in the manual?
Describes the initial startup procedure for the UC5 system.
Explains the main run screen interface and mode switching.
Details how errors are displayed and navigated within the system.
Explains the function of manual boom switches and their effect on system mode.
Covers system settings like sensitivity, mode, height, and tip configuration.
Guides users on how to access the UC5 system setup screens.
Details the steps and prerequisites for performing automatic system setup.
Explains when and how to recalibrate the hydraulics of the UC5 system.
Overview of the options menu for configuring system features like Remote Switches and Headland Assist.
Lists compatible devices for using NORAC Solutions online support.
Lists compatible web browsers for accessing NORAC Solutions online support.
Procedure for testing the functionality and readings of height sensors.
Tests the communication status between system components and the CANbus.
Verifies the proper operation of all boom movement functions.
Covers hydraulic system checks, failure modes, and troubleshooting.
Procedures for adjusting, calibrating deadzones, gains, and boom geometry.
Instructions for replacing height/roll sensors, input/valve modules, and control modules.
Routine tasks for daily upkeep of the sprayer boom, including greasing pads and cleaning sensors.
Detailed instructions for cleaning the ultrasonic height sensors' foam and mesh components.
Guides sensor setup and configuration within the UC5 menu structure.
Details the setup and calibration procedures for system valves in the menu.
Explains how to configure manual remote switches within the UC5 menu.
General| Manufacturer | Norac |
|---|---|
| Category | Controller |
| Supply Voltage | 24 VDC |
| Number of Inputs | 8 |
| Protection | IP20 |
| Compatibility | Universal |
| Control | Programmable |
| Communication | RS485, Modbus RTU |
To Next Page
