Norac UC5 - UC5 Operation; Initial Start Up; Main Run Screen


6

3 UC5Operation
NOTE: Somefunctionsandfeaturesmaynotbeavailableforallsprayermakesandmodels.Consultyour
salesrepresentativeortechnicalsupportwithanyquestionsorconcerns.
3.1. InitialStartUp
On the initial startup and after confirming the legal disclaimer, a screen will appear informing the
operatorthatanautomatic
setupmustbeperformed.Afterconfirmingthisscreen,theautomaticsetup
will begin.The automatic setup reminder at startup willalso be showneach timea firmware updateis
performed.
3.2. MainRunScreen
Oncethesystemiscorrectlyconfigured,itisverysimpletouse.Afterconfirmingthelegal
disclaimer,the
runscreenwillappear.Foravirtualterminal,fromthedisplay’sstartupscreen,selecttheUC5™icon.An
imageoftheboomwiththeheightofeachboomsectionisdisplayedasshowninFigure1.
To change between automatic and manual mode, select the corresponding AUTO (A)
 or MANUAL (M)
button.When the UC5 system is in manual mode, the height displayed under each boom section is
measured from the spray nozzles to the soil (Soil Mode™) or crop canopy (Crop Mode™ or Hybrid
Mode™).If there are five height sensors on the sprayer, the height displayed
is the average for each
boomsection.
WhentheUC5systemisinautomaticmode,arrowswillappearonthescreenaboveorbelowtheboom
sections.These arrows indicate the UC5 system is making a correction to part of the boom in the
displayeddirection.Oftenthecorrectionwillbe
verysmallandtheremaynotbeanoticeablechangein
boomposition.