Norac UC5 - Page 30


28

SetpointBump
Whenthisoptionisenabled(checked),themainliftsprayerswitchisusedtoincrease/decreasethetarget
heightwhilerunninginautomaticmode.NotewhenTerrainAssist™isenabledorHeadlandAssist™isset
tomainlifttrigger;theSetpointBumpcannotbeenabled.
TerrainAssist
WhenTerrainAssistisenabled(checked),tappingthemainliftswitchupwillactivateTerrainAssist.When
activated,bothwingsectionswillraiseasquicklyaspossibletotheTerrainAssisttargetheight(adjustable
wheninTerrainAssistbymodifyingtheheightonthesettingsscreen)andwill
continuetocontrolatthis
heightautomatically.Bypressingthemainliftswitchdownmomentarily,thesystemwillreturntoregular
automatic operation.Note the Setpoint Bump and Headland Assist cannot be active for the main lift
whiletheTerrainAssistfeatureisenabled.
DoubleTapWings
Whenthisoptionisenabled(checked),thesystemcanbeputintoautomaticmodebytappingeitherthe
left down switch or the right down switch twice provided that at least one boom section is already in
automaticmode.Holdinganyoftheupordownswitches
willstillputthesystemintomanualmode.
MinimumBoomHeight
TheMinimumBoomHeightindicatesthelowestmechanicalheighttheboomcouldachieve.Thisfeature
allowstheoperatortosetaminimumheightthatwillnotbeexceededbytheautomaticcontrolsystem.