Norac UC5 - Page 40


38

ReconnectingDevices
Oncethecablingisconfirmedtobeacceptablebyperformingtheshortandopencircuittests,reconnect
thedevicesoneatatimetotesteachdeviceindividually.
1. Turnoffthesystempower.
2. ReconnectonedevicetotheCANbus.
3. Turnonthesystempower.
4.
Checkthecommunicationstatusaspreviouslyexplained.
5. Ifthedeviceisnotcommunicating,removeit.
6. Ifthedeviceiscommunicating,leaveitconnected.
7. Repeatsteps1to6foreachofthedevicesuntiltheyareallconnectedtotheCANbus.Replaceany
devicesthatdonotcommunicate.


