Norcold N8DCX - Troubleshoot Electronic Control Fault Codes (contd); Fault Code - E2

Fault Code - "E2"
Is
thermistor
wire
connected?
Correct connection.
NO
Make sure thermistor in the freezer
compartment is connected.
Remove thermistor cover in freezer
compartment and check connection of
thermistor wire to thermistor.
YES
Complete the “Diagnostic Pre-Checks.”
Is
thermistor
wire
connected?
Correct connection.
NO
YES
Check connection of thermistor wire to
the refrigerator electronic controls.
Refer to the wiring diagram.
Replace Thermistor.
NOR000979A
E2
Possible Cause:
The freezer thermistor is not
cycling properly.
Troubleshooting Electronic Control Fault Codes, cont’d.
SERVICE MANUAL
25
www.norcold.com