Fault Code - "E3"
Correct the DC input voltage to the refrigerator. Make sure the
input voltage is 12.0 VDC.
E3
Possible Cause:
The voltage is outside the cut-out
setting.
Fault Code - "E4"
Make sure:
■ the light switch closes when the door closes.
■ all of the connections to the refrigerator electronic controls are
intact.
E4
Possible Cause:
The door has be open for more
than two (2) minutes.
Troubleshooting Electronic Control Fault Codes, cont’d.
26
www.norcold.com N8DCX, N10DCX Models