Nordberg GP Series User Manual

Version 3/01 Page 20/25
Select language
•
Enter main menu (Press F7 a sufficient number of times).
•
Select system parametres (Press F3).
•
Select user setup (Press F1).
•
Select language settings (Press F1).
•
Highlight desired language (F5 up, F6 down).
•
Select language (Press F4).
•
Press F7 to exit.
Select metric or imperial units
•
Enter main menu (Press F7 a sufficient number of times).
•
Select system parametres (Press F3).
•
Select user setup (Press F1).
•
Change units (Press F2).
•
Press F7 to exit.
Change time/date
•
Enter main menu (Press F7 a sufficient number of times).
•
Select system parameters (Press F3).
•
Select user setups (Press F1).
•
Select change time/date (Press F3).
•
Press F7 to exit.
5. Error/information messages
5.1 Sensor faults
5.1.1 Setting
Minimum setting
•
You have reached the mininum allowed closed side setting of the crusher. Setting must
be increased to continue crushing.
Maximum setting
•
You have reached maximum allowed setting. Setting must be decreased.
Fault in setting sensor!
•
The output of the setting sensor is below working limit. Check the sensor and cables.
Replace if necessary.
Setting sensor ok
•
There was a fault in setting sensor, but the sensor has recovered.
5.1.2 Pressure
Maximum pressure reached!

Nordberg GP Series Specifications

General

Brand	Nordberg
Model	GP Series
Category	Controller
Language	English