8
1. Make sure that the power cord is unplugged. Remove
the indicated screws from the Console Back (89).
Important: The screws may be different lengths; note
which screws were removed from which holes.
Remove the Console (81).
2. Peel the paper off the pad on the bottom of the receiver
(A). Turn the receiver so the cylinder is on the side
shown, and press the receiver into the Console Base
(80) in the indicated location.
3. Connect the included short jumper wire (B) to the wire on
the receiver (A). Connect the other end of the short
jumper wire to the PLS2 jack on the back of the console
(81). If there is a wire already plugged into the PLS2 jack,
unplug it. Note: The other wires included with the receiver
may be discarded. The wire tie can be used to tie wires, if
needed.
Make sure that no wires are pinched. See step 1.
Reattach the Console (81) with the screws. Important: If
the screws are not put back into the same holes from
which they were removed, the Console will be dam-
aged.
89
81
Screws
1
2
80
A
Cylinder
3
81
A
B
PLS2
Jack
If you purchase the optional chest pulse sensor (see page 25), follow the steps below to install the re-
ceiver and the short jumper wire included with the chest pulse sensor.
To Next Page
Loading...
Need help?
General
