14
11. Tighten two #8 x 1" Pan Head Screws (98) into
the bottom of the console assembly (F) in the
location shown.
11
98
F
10. Insert the Upright Wire (81) through the two
indicated looped ties (I) on the console assembly
(F).
See the inset drawing. Connect the Upright
Wire (81) to the console wire (J). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie
from the Upright Wire.
10
I
I
J
F
81
To Next Page
Loading...
