12
11
7
4
110
111,
146
11. See step 7. Tighten the four M10 x 25mm
Screws (92).
Next, have a second person hold the Console
(7) near the Upright (4). Connect the wires on
the Console to the Main Wire (110) and to the
Left and Right Extension Wires (111, 146).
IMPORTANT: The wire connectors should
slide together easily and snap into place with
an audible click. If they do not, turn one con-
nector and try again. You must connect the
wires properly for your elliptical to function
properly.
Then, insert the connectors and the excess wire
into the Console (7).
92
92
12
Avoid pinching
the wires
7
101
128
12. If there is a hang tag (not shown) attached to the
Console Bracket (128), discard the hang tag.
Avoid pinching the wires. Attach the
Console (7) to the Console Bracket (128) with
four M4 x 16mm Screws (101); start all four
Screws, and then tighten them.
101
To Next Page
Loading...
