MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
BATTERY REPLACEMENT
If the console display becomes dim when the console
is operating with batteries, the batteries should be
replaced; most console problems are the result of low
batteries. IMPORTANT: If the elliptical exerciser
has been exposed to cold temperatures, allow it
to warm to room temperature before inserting bat-
teries into the Console. If you do not do this, the
console displays or other electronic components
may become damaged. To replace the batteries,
remove the two screws, which are marked with a bat-
tery symbol, from the back of the console, and remove
the battery cover. Insert four 1.5V "D" batteries into the
console. Orient the batteries as shown by the mark-
ings inside the battery compartment. Then, reattach
the battery cover.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip pulse sensor, or if the displayed
heart rate appears to be too high or too low, see step
5 on page 15.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical exerciser rocks slightly on your floor
during use, see HOW TO LEVEL THE ELLIPTICAL
EXERCISER on page 12.
21
To Next Page
Loading...
Need help?
General
