NordicTrack Audiostrider Cx650 Elliptical - Page 10

10
11. Orient a Link Arm (30) as shown. Attach the
Left Pedal (34) to the Link
Arm with three
M8 x 45mm Button Screws (90), three M8 Split
Washers (97), and three M8 x 23mm x 2mm
Washers (96).
Attach a Pedal Arm Cover (39) to the Link
Arm (30) with an M4 x 16mm Round Head
Screw (78).
Repeat this step for the Right Pedal (not
shown) and the other Link Arm (not shown).
11
34
96
96
97
97
90
30
78
39
10. While another person holds the Console (11)
near the Upright (10), connect the console wire
h
arness to the Upper Wire Harness (65).
A
ttach the Console (11) to the Upright (10) with
four M4 x 16mm Round Head Screws (78).
Avoid pinching the wire harnesses during
this step.
10
78
65
Console Wire
Harness
11
Avoid pinching the
wire harnesses
during this step
10