NordicTrack C100 User Manual (English)

Questions and Answers:

S
Spencer ParksJul 27, 2025
What to do if my NordicTrack C100 Treadmill power turns off during use?
- K
  kempdestinyJul 27, 2025
  If your NordicTrack Treadmill's power turns off during use, try these steps: First, check the power switch and reset it if it has tripped by waiting five minutes before pressing it back in. Ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, and plug it back in. Also, remove and reinsert the key from the console. If the treadmill still won't run, more assistance is needed.
R
Robert NelsonAug 1, 2025
How to fix a NordicTrack C100 that does not turn on?
- F
  frank45Aug 1, 2025
  If your NordicTrack Treadmill doesn't turn on, ensure the power cord is plugged into a properly earthed outlet, using a suitable extension cord if needed (3-conductor, 14-gauge, no longer than 5 ft.). Also, confirm that the key is correctly inserted into the console. Check the power switch located on the treadmill frame near the power cord. If the switch has tripped (protrudes), wait five minutes, then press it back in to reset.
J
Jonathan WebbAug 5, 2025
How to turn off demo mode on NordicTrack C100?
- T
  Tiffany AustinAug 5, 2025
  If the console displays on your NordicTrack Treadmill remain lit even after you remove the key, the display demo mode is likely activated. This mode is intended for use in retail settings. To disable it, press and hold the Stop button for a few seconds.
J
Jeffrey SimpsonAug 11, 2025
How to stop the walking belt from slipping on my NordicTrack C100?
- C
  Carlos SandersAug 11, 2025
  If the walking belt on your NordicTrack Treadmill slips when you walk on it, use the hex key to turn both idler roller screws clockwise, 1/4 of a turn. Make sure that when the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches off the walking platform. Keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
J
jasonrobinsonAug 20, 2025
What to do if the walking belt is not centered on my NordicTrack Treadmill?
- E
  Edward LynchAug 21, 2025
  If the walking belt on your NordicTrack Treadmill is not centered between the foot rails, and it has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill.