Ifyoupurchasetheoptiona!chestputsesensor(seepage22),followthestepsbelowtoinstallthere-
ceiverandtheshortjumperwireincludedwiththechestputsesensor.
1, Makesurethatthepowercordis unplugged.Remove
theindicatedscrewsfromtheConsobBack(88),
(Important:Thescrewsmaybedifferentlengths;
makesuretoremembertheodgina!tocationofeach
screw.}Next,removetheConsobBack,
88
Screws
2, PeeUthepaperoffthepadonthebottomofthereceiver
(A),Turnthereceiversothesmallcylinderisonthe
sideshown,andpressthereceiverintotheConsob
Base(81)intheindicatedbcation,
%
Cylinder
\
3, Connect the included short jumper wire (B) to the wire on
the receiver (A), Connect the other end of the short
jumper wire to the PLS2 jack on the underside of the
Console (82), (Note: if there is already a wire in the PLS2
jack, unplug it,) Discard the other wires included with the
receiver, Use the included wire tie to secure the wires, if
needed,
Make sure that no wires are pinched. See step 1,
Reattach the Console (82) with the screws, Important: If
the screws are not reattached in their original loca-
tions, the Consote may be damaged.
82
PLS2
Jack
To Next Page
Loading...
