13
10. Insert the Upright Wire (81) through one looped
tie (I) on the console assembly (F), and insert
the console wire (J) through the other looped tie.
Connect the Upright Wire (81) to the con-
sole wire (J). The connectors should slide
together easily and snap into place. If they
do not, turn one connector and try again. IF
YOU DO NOT CONNECT THE CONNECTORS
PROPERLY, THE CONSOLE MAY BECOME
DAMAGED WHEN YOU TURN ON THE
POWER.
Pull the ties (I) tight around the Upright Wire
(81) and the console wire (J), and then cut off
the end of each tie.
10
I
I
J
F
81
11. Tighten two #8 x 1" Screws (50) into the console
assembly (F).
11
50
F
To Next Page
Loading...
