NordicTrack Cx 1600 Elliptical - Page 7

7
3. Attach the Track Frame (4) to the Frame (1) with
two M10 x 123mm Button Screws (87) and two
M10 Split Washers (85). Finger tighten a Button
Screw into the lower hole first, and then finger
tighten a Button Screw into the upper hole.
Then, tighten both Button Screws. Note: This
step may be easier if you raise the Frame a few
inches in the location shown by the arrow at the
right while you attach the Track Frame.
See the inset drawing, tighten two Leveling Feet
(36) into the underside of the Track Frame (4).
85
4
1
87
85
87
3
4. Apply a small amount of the included grease to
the sides of two Wave Washers (88) and two
Thrust Washers (66).
Slide a Weld Spacer (89) onto the Left Crank
Arm (83). Next, identify the Left Track Arm (12),
which is marked with an “L.” Orient the Left
Track Arm as shown, and slide it onto the Left
Crank Arm. Then, slide a Wave Washer (88)
onto the end of the Left Crank Arm.
Slide an M8 Small Washer (18) and an Axle
Cap (41) onto an M8 x 19mm Button Screw
(56). Next, slide a Thrust Washer (66) onto the
shoulder of the Axle Cap. Then, tighten the
Button Screw into the end of the Left Crank Arm
(83). Make sure that the Thrust Washer re-
mains on the shoulder of the Axle Cap, and
that the Wave Washer (88) remains on the
end of the Left Crank Arm.
Repeat this step to attach the Right Track Arm
(11) to the right side of the elliptical exerciser.
11
4
83
89
88
41
56
12
18
66
Grease
4
36