9
7
. Identify the Left Handlebar (19), which is marked
with an “L.” Insert the Left Handlebar into one of
the Handlebar Legs (17). Next, turn the Left
Handlebar and the Handlebar Leg so that the
w
ide side of the pivot tube on the Left
Handlebar is above the hexagonal holes in
t
he Handlebar Leg. Attach the Left Handlebar
with two M8 x 38mm Button Bolts (58) and two
M8 Nylon Locknuts (72). Make sure that the
Nylon Locknuts are inside of the hexagonal
holes. Do not tighten the Button Bolts yet.
Assemble the Right Handlebar (20) and the other
Handlebar Leg (17) in the same way.
7
8. Apply a small amount of grease to the sides of
two Wave Washers (88) and two Thrust Washers
(66).
Slide the Left Handlebar (19) onto the
Handlebar Axle (16) as shown. Next, slide a
Wave Washer (88) onto the end of the
Handlebar Axle.
Slide an M8 Small Washer (18) and an Axle
Cap (41) onto an M8 x 19mm Button Screw
(56). Next, slide a Thrust Washer (66) onto the
shoulder of the Axle Cap. Then, tighten the
Button Screw into the end of the Handlebar Axle
(16). Make sure that the Thrust Washer re-
mains on the shoulder of the Axle Cap, and
that the Wave Washer (88) remains on the
end of the Handlebar Axle.
Assemble the Right Handlebar (20) in the same
way. Then, tighten both M8 x 19mm Button
Screws (56) at the same time.
8
1
56
18
56
41
41
88
88
16
20
66
18
19
66
19
20
58
58
72
17
17
Hexagonal
Holes
Wide side of
pivot tube
Grease
To Next Page
Loading...
