9
13. Apply a light film of grease to a Pedal Leg Axle (32).
Next, slide a 5mm Spacer (118) onto the Pedal Leg
Axle. Then, slide an M8 Washer (88) and a Pedal Leg
Cover (31) onto an M8 x 23mm Shoulder Screw (115),
and finger tighten the Shoulder Screw into one end of
the Pedal Leg Axle.
Have another person hold the front end of the Left
Pedal Leg (14) inside of the bracket on the Left Upper
Body Arm (11). Insert the Pedal Leg Axle (32) into both
parts; make sure that the 5mm Spacer (118) is
inside of the bracket on the Left Upper Body Arm.
Slide a 5mm Spacer (118) onto the other end of the
Pedal Leg Axle (32). Next, slide an M8 Washer (88)
and a Pedal Leg Cover (31) onto an M8 x 23mm
Shoulder Screw (115), and finger tighten the Shoulder
Screw into the Pedal Leg Axle. Then, tighten both
Shoulder Screws.
Repeat this step on the right side of the elliptical
exerciser.
14. Lift the latch on the underside of the Left Pedal Leg
(14), and set the Left Pedal Leg on the left Crank
Bushing Sleeve (43). Release the lever, and make
sure that the Left Pedal Leg is securely connected to
the Crank Bushing Sleeve.
Connect the Right Pedal Leg (not shown) in the same
way.
See step 5. Tighten the M8 x 69mm Button Bolt (80)
and the two M8 x 23mm Button Screws (84).
12. Identify the Left Pedal (13) and the Left Pedal Leg
(14), which are marked with stickers.
Attach the Left Pedal (13) to the Left Pedal Leg (14)
with an M4 x 45mm Screw (108), three M4 x 14mm
Screws (104), and four Star Washers (112).
Attach the Right Pedal (not shown) to the Right Pedal
Leg (not shown) in the same way.
15. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
Bracket
13
115
88
31
11
31
14
Latch
14
43
13
14
104
104
112
112
112
112
14
108
12
115
118
118
Grease
32
88
To Next Page
Loading...
