25
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
e
ven when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, unplug the power cord. Lift the
Latch (50) on the underside of the Left Pedal Arm
(13), and then lift the Left Pedal Arm off the left Pedal
Arm Sleeve (46).
Next, remove the indicated M8 x 25mm Patch Screw
(121), Large Axle Cover (113), M8 Washer (95), and
Pedal Arm Sleeve (46). Using a flat screwdriver, care-
f
ully pry the left Disc (17) off the elliptical.
Next, loosen the Pivot Screw (97). Tighten the Belt
Adjustment Screw (85) until the Drive Belt (38) is tight.
When the Drive Belt is tight, tighten the Pivot Screw.
When you are finished, reattach the left disc and plug
in the power cord.
13
50
46
17
95
46
121
113
85
38
97
To Next Page
Loading...
