10
6. Locate the wire tie (B) in the lower end of the
Upright (4). Tie the wire tie to the Main Wire
(110). Then, pull the upper end of the wire tie
until the Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (110) from fall-
ing into the Upright (4), secure the Main Wire
with the wire tie (B).
1
4
110
B
B
5
6
Avoid pinching
the Main Wire
(110) and avoid
damaging the
tabs (A)
A
4
99
99
110
5. Tip: Avoid pinching the Upper Wire (110).
Avoid damaging the indicated plastic tabs
(A). Have a second person hold the Upright (4)
on the Frame (1).
Attach the Upright (4) with four M10 x 25mm
Screws (99) and four M10 Split Washers (79);
start all the Screws, and then tighten them.
79
79
To Next Page
Loading...
