31
SYMPTOM: The displays of the console do not
function properly
a. If the console does not properly record speed or
distance, remove the key from the console and
UNPLUG THE POWER CORD. Next, remove the
ve #8 x 3/4" Pan Head Screws (13), and carefully
pivot off the Motor Hood (65).
Next, locate the Reed Switch (112) and the Magnet
(114) on the left side of the Pulley (51). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in.
(3 mm). If necessary, loosen the #8 x 3/4" Screw
(3), move the Reed Switch slightly, and then
retighten the Truss Head Screw. Reattach the
Motor Hood (see above), and walk on the treadmill
for a few minutes to check for a correct speed
reading.
b. If the console does not boot up properly, or if the
console freezes and does not respond, reset the
console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (C) on the back
edge of the console. Using a bent paper clip (D),
press and hold the reset button inside the opening,
and have a second person press the power switch
into the on (reset) position. Continue holding the
reset button (C) until the console turns on. When
the reset operation is complete, the console will
turn off and then turn back on. If it does not, use
the power switch to turn the treadmill off and then
on again. Once the console turns on, check for
rmware updates (see step 5 on page 25). Note: It
may take a few minutes for the console to be ready
for use.
65
13
13
13
13
a
114
3
112
3 mm
51
Top
View
b
C
D
To Next Page
Loading...
