To Next PageTo Next PageWhat to do if NordicTrack NTL17919-INT.0 Treadmill power turns off during use?
If the power to your NordicTrack Treadmill turns off during use: * Check the power switch. If it has tripped, wait five minutes and then press the switch back in. * Make sure the power cord is plugged in. If it is, unplug it, wait five minutes, and then plug it back in. * Remove the key from the console, and then reinsert it.
How to reset console on NordicTrack NTL17919-INT.0?
If the displays of the console do not function properly on your NordicTrack Treadmill and the console does not boot up properly, or if the console freezes and does not respond, reset the console to the factory default settings. Resetting the console requires two people. First, press the power switch into the off position. Next, locate the small reset opening (A) on the back edge of the console. Using a bent paper clip (B), press and hold the reset button inside the opening, and have a second person press the power switch into the on position. Continue holding the reset button until the console turns on. When the reset operation is complete, the console will turn off and then turn back on. If it does not, use the power switch to turn the treadmill off and then on again.
Why does my NordicTrack Treadmill walking belt slip when I walk on it?
If the walking belt on your NordicTrack Treadmill slips when you walk on it, first remove the key and unplug the power cord. Then, use the hex key to turn both idler roller screws clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 inches (5 to 7 cm) off the walking platform. Plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
What to do if NordicTrack NTL17919-INT.0 walking belt is not centered?
If the walking belt on your NordicTrack Treadmill is not centered between the foot rails, first remove the key and unplug the power cord. If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclockwise 1/2 of a turn. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is centered.
How to fix NordicTrack NTL17919-INT.0 Treadmill walking belt slowing down?
If the walking belt slows down when you walk on your NordicTrack Treadmill: * If an extension cord is needed, use only a 3-conductor, 14-gauge (2 mm[2]) cord that is no longer than 5 ft. (1.5 m). * If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove the key and unplug the power cord. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Then, plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
General| Brand | NordicTrack |
|---|---|
| Model | NTL17919-INT.0 |
| Category | Treadmill |
| Language | English |
Instructions for safely connecting the treadmill power cord to an electrical outlet.
Step-by-step instructions for folding the treadmill for storage or moving.
Guidelines and precautions for safely moving the folded treadmill.
Instructions for unfolding the treadmill from storage to its operational position.
