13
Turn on the fan if desired.
To turn on the fan at low speed, press the Fan
button; the word “LOW” will appear in the matrix
for a few seconds. To turn on the fan at high
speed, press the button a second time; the word
“HIGH” will appear in the matrix. To select the
auto mode, press the
button again; the word
“AUTO” will appear in
the matrix. When the
auto mode is selected,
the speed of the fan will
automatically increase
and decrease as the speed of the walking belt in-
creases and decreases.
To turn off the fan, press the Fan button again, the
word “OFF” will appear in the matrix. Note: If the
fan is left on when the walking belt is stopped, the
fan will automatically turn off after a few minutes.
When you are finished exercising, remove the
key.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will be damaged. Next, re-
move the key from the console and put it in a se-
cure place. Note: If the display remains lit after
the key is removed, the console is in the
“demo” mode. See page 18 and turn off the
demo mode.
When you are finished using the treadmill,
switch the reset/off circuit breaker to the “off”
position and unplug the power cord.
87
To Next Page
Loading...
Need help?
General
